2-päevane koolitus Medit Master’i Dr. Armen Mirzayan’iga
Saksamaal Heidelbergis, 9.-10. juuli 2021
Koolitajaks on Medit Master, Dr. Armen Mirzayan, kellel on 20 aasta kogemust CAD/CAM süsteemidega. Dr. Mirzayan on ise hambaarst ja oli 15 aastat CEREC Master Trainer. Tänaseks on ta koos oma tiimiga koolitanud IOS teemal üle 15 000 arsti ning on ilmselt üks pädevamaid skannerite spetsialiste kogu maailmas.
Kogu koolituspaketi kulu on vaid 500€ + lennud.
2 päeva koolitust Dr. Armen Mirzayan'iga
Majutus hotellis (2 ööd, 8. ja 9. juuli)
Toitlustus koolituse ajal (kohvipausid ja lõunad)
Õhtusöök: Grand Opening Event Dinner
Edasi-tagasi transport lennujaamast
Hetkel saadaval Lufthansa otselennud Tallinnast Frankfurti edasi-tagasi 218€.
8. juuli Tallinn-Frankfurt 17:35-19:00
10. juuli Frankfurt-Tallinn 21:15-00:30
Koolituse programm
Päev 1: Reede, 9. juuli
09:00 AM – Welcome and Introduction
09:15 AM – Introduction to your new Medit Intra-Oral Scanner
Overview of your new Medit IOS’s operation and possibilities
Appreciate how Medit can work in a typical dental practice
Understand when you can use your Medit IOS
Comprehend latest generation of scanning technology
Learn how to efficiently scan with your new Medit IOS
10:00-10:15 AM – Break
10:15 AM – Scanning Demonstration and Hands-On
Become comfortable scanning on a model
Appreciate the information that is needed to achieve a high-quality scan
Comprehend the difference between good and bad data capture
Learn the pitfalls of over-scanning
12:30 PM – Lunch
13:30 PM – Live scanning in the mouth
Understand how to operate your new IOS intra-orally
Learn proper technique and workflow
Isolation of lips, tongue and tooth preparations
Master the single-unit, multi-unit and full arch digital impression
Scanning for special cases: implants, orthodontics, etc.
16:30-17:30 – Happy Hour (Aperitifs)
18:30 – Group Dinner (location TBD)
Päev 2: Laupäev, 10. juuli
09:00 AM – Welcome Back and Housekeeping
09:15 AM – Introduction to CAD Software Design
Learn about the various CAD softwares available to IOS users
Introduction to Clinux cloud-based CAD Software
Exercises: Learn scanning for CAD Software design
10:00-10:15 AM – Break
10:15 AM – Designing in Clinux CAD Software
Exercises: Learn how to make your own CAD designs
Exercises: Learn how to mill your own restorations
Exercises: Learn how to finish, stain & glaze your own Crowns
12:30 PM – Lunch
13:30 PM – Advanced Techniques with Medit IOS Scanners (i500 and i700)
Learn how to integrate of Cone-beam and .STL data into your workflow
Understand the possibilities of digital implant restorations
Learn scanning techniques for multi-abutments
Learn proper case presentation techniques for patients
16:30 – Happy Hour & Certification (Aperitifs)
17:30 – Course ends
